SANlight FLEX II power supply 150 W without AC connector
Code: N41578Related products
Product detailed description
Hardwired installation
This 150 W power supply is for medium-sized FLEX II installations that connect directly to a fixed electrical supply. The AC side has loose wires instead of a plug, so an electrician must make the mains connection. Choose this version when a plug would get in the way; for a ready-made connection, use the version with a Wieland connector.
Specifications
- Maximum power: 150 W
- Input voltage: 100-240 V AC, multi-range
- Maximum current draw: 0.75 A at 230 V AC
- AC connection: loose wires, no connector
- DC output: WDC21
- Minimum load: 1 x FLEX II 10
Compatible lights and cabling
The power supply supports up to 15 FLEX II 10, 7 FLEX II 20 or 5 FLEX II 25 lights of one type. Use a splitter with a WDC21 male connector at the power supply output: either the four-way or two-way WDC21 splitter. WDC19 extension cables connect the lights to one another.
Incompatible components
- Splitters with a WDC19 male connector, intended for the small GST30/GST65 power supplies, have the wrong output connection.
- EVO/Q-Series and STIXX lights and cabling use a different system. The Wieland connector on those power supplies is for the mains connection, not for powering EVO lights.
- SANlight BT-Dimmer and M-Dimmer units are not compatible with FLEX II; FLEX II has no SANlight dimmer.
Dimming
The power supply has a fixed output, so connected lights run at full power unless a driver that supports an external 0-10 V signal is used for intensity control.
The connector-free version has the same WDC21 DC output, 150 W power and supported light counts as the version with a Wieland connector. Choose between them according to whether the mains connection is made directly to fixed wiring or through a prepared connection.
Additional parameters
| Category: | FLEX II Accessories |
|---|---|
| Weight: | 0.9 kg |
| EAN: | 9120069231540 |
Discussion
Be the first who will post an article to this item!
